A handmade bar asks for a little more than a supermarket bar, and repays it. Ours are hard, long-lasting bars. A handmade bar also keeps its glycerin, the part of soap that draws water toward itself, and a goat's milk bar adds fat that a machine-pressed bar never had. Both mean a bar left standing in water will wear away faster than it needs to. Here is how to make bar soap last longer, and most of it comes down to one habit: let the bar dry.
At the sink and in the shower
The dish matters more than anything else. Use one that drains, with slats, ridges or a raised grid, so the bar sits above the water rather than in it. Set it out of the direct stream of the shower, where the spray cannot reach it between uses, and away from the edge of the sink where a wet hand rests. A bar in a puddle turns to paste on its underside. A bar on a slatted dish dries between uses and keeps its shape. It also lathers better, because the lather is worked up from a firm surface rather than from a layer that has already turned to paste.
If there are two bars in the house, alternate them, so each has a day to dry. A bar that dries fully hardens a little each time, and a hard bar lasts. Where one bar sees several showers a day, cut it in half with a plain kitchen knife. Each half dries faster than the whole. The second half can wait in a drawer with the linens, which does more for the linens than the bathroom cupboard would.
The last sliver, and the bar that travels
The sliver at the end is still soap, and there are two good uses for it. Press it onto the face of a fresh bar while both are wet, and it will fuse as the two dry together. Or keep slivers in a small muslin bag and use the bag itself at the sink. The cloth gives a little texture, and the last of the soap is spent. Nothing needs to be thrown away.
Travelling with a bar is easier than travelling with a bottle, since a bar answers to none of the liquid rules. Let it dry fully before it is packed, then carry it in a lidded tin or a vented travel case. Never seal a damp bar in plastic. It arrives half gone, and the first day of the trip goes to drying it out. For a short stay, cut a piece from the bar and leave the rest at home. At the other end, take the piece out of its tin and set it somewhere it can dry.
All of this holds across the goat milk bars, scented or not. The habits are small. Together they are the difference between a bar that lasts as long as it was made to and one that is gone well before it should be.
The scrubs and the tapers
The same idea applies in the copper tins. A sugar scrub is sugar suspended in oil, and sugar dissolves the moment water reaches it. The tin stays out of the shower's reach, then, and the lid goes back on after every use. Take the scrub out with dry fingers or a small spoon, then close it. If the oil rises to the top between uses, that is the oil settling, not a fault. Stir it back through and it is as it was. Copper also darkens where water sits on it, which is one more reason to keep the tin dry.
Beeswax tapers ask for three things. Trim the wick to about a quarter of an inch before each lighting, so the flame stays even and the wax burns rather than smokes. Keep the candle out of drafts, since a moving flame burns down one side and sends wax over the edge. Never leave a lit taper unattended, and put it out before it reaches the holder. Between uses, stand the tapers somewhere cool and out of the sun, since warm beeswax softens and leans. A pale film on the wax is bloom, a habit of beeswax, and it buffs away with a soft cloth.
Soap, sugar and wax are three different materials. The care is the same in spirit. Keep water off the soap and out of the tin, keep heat and drafts off the wax, and each will last as long as it was made to.